Mass Storage
Physical Model
A mass storage unit draws/injects a specified mass flow from/into the connected junction. It is implemented similar to a sink, i.e. positive mass flow values correspond to charging of the storage unit, negative mass flows means discharge of the storage unit.
The mass storage component is meant for all storage applications that do not involve relevant temperature changes or changes in the fluid’s composition, e.g., a water tower. It is always assumed that the discharged fluid is of the same temperature and composition as the fluid at the junction where the unit is connected to.
In stationary calculations (c.f. The Pipeflow Function), it acts as a simple sink/source,
without changing m_stored_kg
(since the duration of the mass flow is unknown).
For dynamic behaviour across time steps, an accompaning BasicController has to be implemented,
in which the charging / discharging behaviour and duration of timesteps is defined.
The dynamic calculation can then be started by run_control (for one time step) or
run_timeseries for time series.
Tip
An example storage controller can be found in the respective tutorial.
Warning
This component is only intended for mass storage applications and will likely lead to wrong results if it is used for district heating network applications.
Create Function
For creating a single mass storage:
Component Table Data
net.mass_storage
Parameter 
Datatype 
Value Range 
Explanation 
net 
pandapipesNet 
The pandapipes net object in whose 

junction 
integer 
> 0 
Index of connected junction 
mdot_kg_per_s 
float 
> 0: charging,< 0: discharging 
Mass flow in stationary pipeflow calculation [kg/s] 
init_m_stored_kg 
float 
greq 0 
The initially stored mass in the storage in kg. 
min_m_stored_kg 
float 
greq 0 
Minimum amount of fluid that can be stored in the storage unit. (To be used with controllers) 
max_m_stored_kg 
float 
> 0 
Maximum amount of fluid that can be stored in the storage unit. (To be used with controllers) 
scaling 
float 
> 0 
An optional scaling factor to be set customly (default 1.0). Factor will be applied on 
name 
string 
Name of the mass storage unit 

index 
integer 
> 0 
Force a specified ID if it is available. Default None, i.e. the index one higher than the highest already existing index is selected. 
in_service 
boolean 
True / False 
Specifies if the mass storage is in service. 
type 
string 
Component type (default ‘mass_storage’), can be used to distinguish between different kinds of mass storage. Not considered by pandapipes’ calculations. 
Result Table Data
net.res_mass_storage
Parameter 
Datatype 
Explanation 
mdot_kg_per_s 
float 
mass flow [kg/s] (> 0: charging / < 0: discharging) 
More columns may be added by controller implemente by the user,
e.g., m_stored_kg
, filling_level_percent
, etc.